For direct drive, the full length of the nozzle. For Bowden, the full length of the tube and nozzle. #define FILAMENT_CHANGE_UNLOAD_LENGTH 10 // (mm) The length of filament for a complete unload. #define FILAMENT_CHANGE_UNLOAD_ACCEL 20 // (mm/s^2) Lower acceleration may allow a faster feedrate. #define FILAMENT_CHANGE_UNLOAD_FEEDRATE 10 // (mm/s) Unload filament feedrate. Really the only main one anyhow is the stock filament load and unload is set at like 400+ mm at about 40mm/s (cant recall actual values) but ungodly high you may what to update that in your configįound this to be more suiting and not filament chewy Hey eric thanks for the work you have done on this firmware couple of things i have noticed I think we have a slightly different printer – I have the CR-10 V2 + Creality BLTouch so a simple firmware drop-in would not work, I will prolly need to recompile from the basic each toolchain I’m trying seems to have some bug at a certain step, I’m a bit p!ssed. Note: bltouch bed leveling behavior from 2.0.5 to 2.0.6 has changed: with 2.0.5 at each point probed, the bltouch probe pin would stove with >2.0.6, the pin will become red for an instant then the carriage move to the next point. If you sligthly press the carriage bridge on one side, you will end up misaligning this won’t happen with the other printer. Yep, that X arm issue happened to me too – I have another printer and can tell that those steppers are a bit underpowered. I have read that is a known bug of that release I should enable the standard jerk routine as the “advanced” is failing. I haven’t much time to dedicate to this project, unfortunately.Ĭurrent issue with 2.0.5 – the jerk model for movement is not correct: the carriage is standing in the same place too much and the filament will ooze at each corner. I am a windows user still need to setup octoprint over Raspi 3 and dedicate it to printing: I have tried to run it in a container with no luck so far. This runs Marlin 2.0.7 on CR10v3 without the BLTouch. #define Z_MIN_PROBE_ENDSTOP_INVERTING false // ENABLED(CR10V2_BLTOUCH) // Set to true to invert the logic of the probe. #define Z_MAX_ENDSTOP_INVERTING false // ENABLED(CR10V2_BLTOUCH) // Set to true to invert the logic of the endstop. #define Y_MAX_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop. #define X_MAX_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop. #define Z_MIN_ENDSTOP_INVERTING false // ENABLED(CR10V2_BLTOUCH) // Set to true to invert the logic of the endstop. #define Y_MIN_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop. #define X_MIN_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop. Mechanical endstop with COM to ground and NC to Signal uses “false” here (most common setup). Line # 665, 668 & 669 set to false and removed the ENABLED(CR10V2_BLTOUCH) Then I recompiled a Version of your own code with the line changes: this did not properly work since i do not have the BLTouch. I first tried it with your precompiled version of 2.0.7.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |